1. Confirm conditions before operation. The equipment is suitable only for use on hardened surfaces that are level, firm, and free of slopes. Soft ground, areas with oil or standing water, trenches, and pronounced steps can easily cause slipping, sinking, or loss of control. Do not exceed the equipment’s load capacity, and do not place the load off-center or operate with only one fork. Keep the load as centered and low as possible; use extra caution and move especially slowly when the load’s center of gravity is high. Before use, check for deformed or jammed wheels, loose connectors, responsive remote-control buttons, and sufficient battery charge for the planned handling task. Untrained personnel must not operate the equipment.
2. Move slowly and steadily. Start, stop, accelerate, and turn smoothly. Sudden stops or sharp turns can cause the load to sway due to inertia and may even result in a tip-over. Travel at low speed throughout, and slow down in advance before turning. When operating with a wireless remote control, the operator should stand at a safe distance and ensure they can observe the equipment and the area around the load. Assistants must also keep a sufficient distance from the equipment and its route, and must not stand in the load’s blind spots or in the equipment’s direction of travel.
3. Slopes require particular caution and should be treated as prohibited areas. As a rule, never use electric transporters on any slope. These machines cannot be parked as reliably as vehicles, and a slope amplifies inertia, which can cause the equipment to roll, become uncontrollable, or even tip over. Even if the site has only a slight gradient, first verify the actual conditions and load status, and have qualified personnel assess whether passage is safe. Never start, stop, turn, or position the equipment on a slope. Passage must be prohibited where there is a cross-slope. If safety cannot be confirmed, treat the route as impassable.
4. Charge the battery properly. Charge in a well-ventilated area, away from open flames and sparks. Use the supplied charger or a dedicated charger compatible with the battery type; do not use chargers intended for different types of batteries interchangeably. Disconnect the charger promptly once charging is complete to avoid overcharging. If the equipment will be out of use for an extended period, recharge the battery periodically to prevent damage from deep discharge.
5. Park the equipment properly and respond appropriately to abnormalities. After operation, lower the load-bearing surface to a position close to the ground, park in a designated level area, and switch off the power. If unusual noises, signs of loss of control, or remote-control failure occur during operation, press the emergency stop button immediately, stop operating, and investigate the cause. Do not continue working with faulty equipment.